Work-sharp WS3000 Tool Bar Attachment User Manual

BA123TOOL STICKOUTTOOL STICKOUTWS3000Tool Bar AttachmentUser’s GuideParts Included:• Tool Bar• Bracket Assembly• Set-Up Fixture• P80 AbrasiveABCDABCDA

Roughing Gouge(11) Multi Jig Tormek® SVS-50 with Roughing GougeUse Vee Plate fixture when sharpening Roughing GougesSee Roughing Gouge Set Up Ch

Parting Tool(12) Multi Jig Tormek® SVS-50 with Parting ToolUse Vee Plate fixture when sharpening Parting ToolsSee Parting Tools Set Up Chart (Se

Skew Chisel(13) Multi Jig Tormek® SVS-50 with Skew ChiselUse Skew Tool fixture when sharpening Skew ChiselSee Skew Chisel Set Up Chart (Section 10) f

JS 0JS 6(14) Gouge Jig Tormek® SVS-185 SettingsThis chart shows how changing the JS angle of the Gouge Jig will change the grind profile. Se

(15) Gouge Jig Tormek® SVS-185 SettingsGrind Angle32°35°39°42°TSOSettingAAAAHeight Setting0123JS Setting0000Tool RestPostitionBBBBBowl Gouge JS 0Grin

(16) Gouge Jig Tormek® SVS-185 TechniqueTechnique:When sharpening a tool with swept back sides, do not over grind the center of the tool. Spend most

(17) Gouge Jig Tormek® SVS-185 Tips1 Sharpening with the jig in setting JS 0 requires little travel of the jig while sharpening. As you incr

Position APosition BMicro-Adjust knobwith index markTool BarSecuring knob(1) Set Up Instructions:1 Insert tapped end of bar into the tool bar kn

(3) Tips and Techniques(2) AbrasivesHeat Control:Be aware of your tool’s temperature to avoid burning the steel. Monitor the tool’s heat with yo

BA123TOOL STICKOUTTOOL STICKOUTH1H2H3TSO ATSO BTSO ATSO BH1 H3(4) Set Up FixtureSetting the Tool Bar Height (H)There are three height (H) settings for

(5) Freehand Topside(6) Freehand UndersideThe Tool Bar can be placed under the grinding wheel on the back side of the machine. This prov

(7) Data ChartUse this data chart to record your sharpening set ups on various tools to increase repeatability and reduce your set up tim

Tip: Move the tool from one side to the other on the tool rest in a smooth, steady motion. This will create a consistent cutting edge. Avoid starting

Tip: Move the tool from one side to the other on the tool rest in a smooth, steady motion. This will create a consistent cutting edge. Avoid starting

(10) Multi Jig Tormek® SVS-50 Set Up1Place Tool Bar in Position ‘B’.Grind Angle30°38°47°TSOSettingBBBHeight Setting123Tool RestPostitionBBBRoughing G